STEEL BAR BENDING MACHINE RB60-E55 a high-efficiency steel bar bending machine designed for reinforced concrete construction. It bends steel bars within its rated capacity with precision, driven by a reliable electric motor for dependable performance on demanding job sites.
2. Technical Specifications
Item
Specification
Model
RB60-E55
Bending Capacity
≤Φ60mm
Thickness
45mm
Spindle Speed
8r/min
Motor Power
5.5kw
Dimension
1200×820×770mm
Weight
≈580kg
3. Intended Use & Applications
STEEL BAR BENDING MACHINE RB60-E55 is widely used for bending steel bars and reinforcing steel in:
Rebar fabrication workshops
Building foundations
Bridge construction
Precast concrete plants
Structural stirrups, hooks, and shaped bars for columns, beams, and slabs
4. Operation Guide
Place the machine on a level, stable surface. Verify the working voltage matches your power supply.
Connect the power cord to a properly grounded outlet.
Select the bending pin according to the required bend diameter.
Insert the steel bar and position it against the stop guide.
Start the machine and let the arm complete the bending cycle.
Remove the bent bar and continue the next piece.
Note: Do not exceed the maximum rated bending diameter of the machine. Bending larger bars may damage the machine or produce inaccurate bends.
5. Safety Instructions
Warning: This machine has moving bending components. Serious injury can occur if misused.
Operate the machine only after reading this manual and receiving proper training.
Wear safety goggles, gloves, and protective footwear when operating.
Keep hands away from the bending arm and rotating parts at all times.
Disconnect power before changing pins, cleaning, or maintenance.
Never attempt to bend bars beyond the rated capacity.
Use only genuine Creare replacement parts.
6. Maintenance
Inspect the bending pins and discs for wear before each shift.
Lubricate the rotating mechanism and gears according to the maintenance schedule.
Check bolts and fasteners periodically for tightness.
Keep the machine clean and free of scale and debris.
Store the machine in a dry, covered area when not in use.
