RIDE-ON POWER TROWEL DMR-800GS a concrete power trowel designed for professional floor finishing. It delivers smooth, level surfaces with precision blades running at high speed, powered by a reliable engine for consistent performance on large concrete pours.
2. Technical Specifications
Item
Specification
Model
DMR-800GS
Engine Model
20HP/24HP
Plate Specification
1.8mm*800mm
Blade Specification
1.2mm*125mm*260mm
Blade Speed
120-140r/min
Trowel diameter
800mm
Gasoline Tank
15.5L
Working voltage
About 3 hours
Gross weight
310kg
3. Intended Use & Applications
RIDE-ON POWER TROWEL DMR-800GS is used for concrete surface finishing in:
Warehouse floors
Factory slabs
Parking lots
Commercial building construction
Large concrete pours
4. Operation Guide
Position the trowel on the finished concrete surface and check fuel or power supply.
Start the engine and let it warm up.
Engage the blade drive and set the blade pitch for the finishing stage.
Guide the trowel across the surface in overlapping passes.
Adjust blade pitch as the concrete hardens for final finishing.
Note: Use the correct blade type and pitch for each stage of concrete finishing. Consult the concrete mix and curing requirements.
5. Safety Instructions
Warning: This machine has rotating blades. Serious injury can occur if misused.
Operate the machine only after reading this manual and receiving proper training.
Wear safety goggles, gloves, and hearing protection when operating.
Keep hands and feet away from the rotating blades.
Turn off the engine before adjusting blades or maintenance.
Never operate with damaged or missing blades.
Use only genuine Creare replacement parts.
6. Maintenance
Inspect blades for wear and replace in sets as needed.
Check engine oil and fuel levels before each shift.
Clean the machine after each use to prevent concrete buildup.
Check bolts and fasteners periodically for tightness.
Store the machine in a dry, covered area when not in use.
