ELECTRIC MILLING MACHINE MI-250E a milling machine and floor grinder designed for surface preparation and floor repair. It operates with blades within its rated diameter at high speed, powered by a powerful motor for efficient material removal on concrete and floor surfaces.
2. Technical Specifications
Item
Specification
Model
MI-250E
Depth
3-6mm
Width
250mm
Power
7.5KW
Weight
136KG
3. Intended Use & Applications
ELECTRIC MILLING MACHINE MI-250E is used for surface preparation and grinding in:
Warehouse floors
Factory floors
Parking decks
Removing old coatings
Preparing concrete for epoxy, paint, or overlay
4. Operation Guide
Place the machine on the surface and check the power supply.
Select the appropriate grinding disc for the material and finish required.
Start the machine and allow it to reach operating speed.
Guide the machine across the surface in overlapping passes.
Adjust pressure and speed for the desired removal rate and finish.
Note: Use the correct grinding disc type for the surface and application. Do not force the machine beyond its rated capacity.
5. Safety Instructions
Warning: This machine has a rotating grinding head. Serious injury can occur if misused.
Operate the machine only after reading this manual and receiving proper training.
Wear safety goggles, gloves, and a dust mask when grinding.
Keep hands and loose clothing away from the rotating head.
Disconnect power before changing discs or maintenance.
Never operate the machine with the safety guard removed.
Use only genuine Creare replacement discs.
6. Maintenance
Inspect grinding discs for wear and replace as needed.
Check the motor and drive belt condition regularly.
Clean the machine and dust collection system after each use.
Check bolts and fasteners periodically for tightness.
Store the machine in a dry, covered area when not in use.
