CONCRETE SCREED CS-25 a concrete vibrator designed to consolidate fresh concrete and eliminate air pockets for stronger, denser pours. It delivers effective vibration, powered by a reliable motor, and comes with a flexible shaft for easy positioning in forms and deep pours.
2. Technical Specifications
Item
Specification
Model
CS-25
Rated Power
1.6HP
Speed
5200rpm
Gasoline Tank Volume
0.65L
Gross weight
25kg
3. Intended Use & Applications
CONCRETE SCREED CS-25 is used to consolidate fresh concrete in:
Foundations
Columns and beams
Slabs
Precast concrete production
Deep pours and confined forms
4. Operation Guide
Connect the vibrator to the power supply and check the flexible shaft.
Insert the vibrating head vertically into the fresh concrete.
Hold the head in place until air bubbles stop rising (usually a few seconds per point).
Withdraw the head slowly and move to the next insertion point.
Avoid over-vibration, which can cause segregation of the mix.
Note: Do not run the vibrator in air for extended periods, as this may damage the unit. Insert the head into concrete before starting where possible.
5. Safety Instructions
Warning: This equipment vibrates during operation. Use caution to avoid repetitive strain and electrical hazards.
Operate the equipment only after reading this manual and receiving proper training.
Wear safety goggles, gloves, and rubber boots when working with wet concrete.
Keep the motor and electrical connections away from water.
Disconnect power before cleaning or maintenance.
Use only genuine Creare replacement parts.
6. Maintenance
Inspect the flexible shaft and vibrating head for wear before each use.
Clean the vibrating head after each use to prevent concrete buildup.
Check electrical cables and connections for damage.
Lubricate the flexible shaft according to the maintenance schedule.
Store the equipment in a dry place when not in use.
