CONCRETE PAVEMENT CUTTER CPC-180D a concrete cutting machine designed for pavement, joint, and slab cutting. It handles large-diameter blades with a rated cutting depth, powered by a powerful motor for clean, accurate cuts in concrete and asphalt.
2. Technical Specifications
Item
Specification
Model
CPC-180D
Power Type
Diesel Engine
Motor power
9HP
Diameter of blade
300-500mm
Capacity of water tank
36L
Weight
180kg
3. Intended Use & Applications
CONCRETE PAVEMENT CUTTER CPC-180D is used for concrete cutting work in:
Road construction
Pavement repair
Expansion joint cutting
Utility trench work
Concrete and asphalt slabs
4. Operation Guide
Place the machine on a stable surface and check power or fuel supply.
Fill the water tank for wet cutting to control dust and cool the blade.
Position the blade over the cutting line and set the cutting depth.
Start the machine and lower the blade gradually into the material.
Guide the machine along the cutting line at a steady pace.
Note: Use the correct blade type for the material being cut. Do not exceed the rated cutting depth.
5. Safety Instructions
Warning: This machine has a rotating cutting blade. Serious injury can occur if misused.
Operate the machine only after reading this manual and receiving proper training.
Wear safety goggles, gloves, and hearing protection when operating.
Keep hands and body parts away from the rotating blade.
Disconnect power before blade replacement, cleaning, or maintenance.
Never operate the machine with the blade guard removed.
Use only genuine Creare replacement blades.
6. Maintenance
Inspect the blade for wear and damage before each shift.
Check water tank and pump operation regularly.
Check drive belts and fasteners periodically.
Keep the machine clean and free of concrete debris.
Store the machine in a dry, covered area when not in use.
